CONVENTIONAL DETECTORS
 |
2151BPI | ||
| 2151BPI Photoelectric detectors use state-of-the-art optical sensing chambers and are designed to provide open area protection. The 215BPI can only be used with compatible panels. The ability to plug these detectors into a variety of base options extends panel compatibility and application flexibility. | |||
| (view datasheet) | (view installation note) | (pdf) | |
 |
51A51, 51B51, 51C51, 51D51 | |
| 5151 series combine Electro-pneumatic technology (rate-of-rise operation) and a Thermistor technology (fixed temperature operation to provide reliable detection of heat produced by fire. Australian Standard A, B and C type detectors are available. | ||
| (view datasheet) | (pdf) | |
 |
885WP-B | ||
| 88WP-B is a 2-wire type “B” fixed temperature (63 °C) heat detector. This detector is designed to provide open area protection in areas subject to moisture. This detector is sealed against the entry of moisture to a rating of IP67. | |||
| (view datasheet) | (view installation note) | (pdf) | |
 |
B401 | |
| B401 plug-in Detector Bases are used with System Sensor smoke and heat detector heads. The B401 base is intended for use in 2-wire systems, with screw terminals provided for power and remote annunciator connections. | ||
| (view installation note) | (pdf) | |
|
B401R | |
| The B401R Detector Base is intended for use in 2-wire systems, with screw terminals provided for power, ground, and remote annunciator connections. The B401R base also contains a 470 ohm resistor to provide current limiting in the alarm state. | ||
| (view installation note) | (pdf) | |
 |
WB-1AP-IV | |
| The WB-1 Detector Adapter Base Enclosure is recommended in humid environments and can accommodate B401, B401R and B501 bases. | ||
| (view installation note) | (pdf) | |
 |
1151 Discontinued, but limited stock still available. Please contact your local branch. | ||
| 1151 Ionisation detectors use state-of-the-art sensing chambers. These detectors are designed to provide open area protection and to be used with compatible control panels only. The ability to plug these detectors into a variety of base options extends panel compatibility and application flexibility. | |||
| (view datasheet) | (view installation note) | (pdf) | |
